Machinery Directive And Ce Mark - Eaton Rapid Link 5 Manual

1.7.2 Machinery directive and CE mark

After installation in a machine, the RAMO5 and RASP5 must not be put into
operation until the assigned machine has been confirmed to comply with the
safety requirements of Machinery directive 2006/42/EC (corresponds to
EN 60204). The user is responsible for ensuring the machine application's
compliance with EC directives.
The CE labels applied to the RAMO5 and RASP5 units confirm that the
devices comply with the Low Voltage Directive (2014/35/EC) and the
Electromagnetic Compatibility (EMC) Directive (2014/30/EC).
The RASP5 devices with STO function also comply with the Machinery
Directive 2006/42/EC.
￫
At the output of RAMO5 and RASP5 you must not:
• connect several motors,
• connect a voltage or capacitive loads
(e.g. phase compensation capacitors),
• connect multiple RAMO5 and RASP5 units in parallel,
• make a direct connection to the input (bypass).
The technical data and connection conditions must be observed.
For details, see the rating plate of the RAMO5 or RASP5 and the documenta-
tion.
Any other usage constitutes improper use.
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
1 Rapid Link 5 system
1.7 Proper use
31