Configuring The Ip Address - Eaton Rapid Link 5 Manual

9.2.9 Configuring the IP address

The Rapid Link 5 modules are addressed using MAC and IP addresses.
Each device has a globally unique MAC address (a six-byte Ethernet
address): The first three bytes specify the manufacturer-specific ID, while the
other three bytes specify the device's serial number.
IP address configuration can be changed using the TCP/IP class 0xF5.
￫
The MAC address is printed on the name plate of the
Rapid Link 5 module.
Static IP address: 192.168.1.254
Subnet mask: 255.255.255.0
The following instructions describe how to configure the IP address of the
Rapid Link 5 module.
The configuration is carried out using the software Molex.
￫
Molex can be downloaded from the Internet free of charge at:
https://www.molex.com/molex/contact/icccDownload.jsp
Perform the following instructions :
▶ Connect the Rapid Link 5 module and the PC on the network side.
▶ Switch on the device.
▶ Open the Molex program.
▶ Click on the Options button.
Figure 118: Options button
▶ Select the PC network adapter and confirm using OK.
Figure 119: Select the PC adapter (interface)
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
9 Communication
9.2 EtherNet / IP
213