Ethernet/Ip Interface Of The Rapid Link 5 Module - Eaton Rapid Link 5 Manual

9.2.3 EtherNet/IP interface of the Rapid Link 5 module

An M12 plug is used to establish a connection to the EtherNet/IP field bus.
The following figure shows the EtherNet/IP interface of the Rapid Link 5
module with two M12 sockets.
Figure 111: EtherNet/IP interface
Generally, connection cables with M12 plugs for EtherNet/IP are available as
standard ready-to-use cables. They can also be prepared individually.
This will require the connections shown below (Observe pin assignment!).
2
1
4
3
5
1 TD+
2 RD+
3 TD-
4 RD-
5 
Figure 112: Pin assignment E/IP P1 AND E/IP P2
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
9 Communication
9.2 EtherNet / IP
205