Configuring The Transport Protocol - Extron electronics VNM EC 200 User Manual

Configuring the Transport Protocol

Use the following procedure to configure the transport protocol that will be used throughout
the VN-Matrix system (see
information on how to log in).
1. Click the Configuration tab.
The Configuration page opens (see figure 13,
2 2
Figure 13.
2. Click the System config link (see figure 13,
3. From the Protocol drop-down list, select the preferred transport protocol that will be
used throughout the VN-Matrix system (
NOTE: The default transport protocol is Unicast. For more information on transport
protocols (see
4. Click Apply Changes (
Accessing the Web‑based User Interface
1 1
3 3
Configuration Page — Configuring the Transport Protocol
Transport Protocols Used for Streaming
), to save the configuration.
4
VNM EC 200 • Single EC 200 Configuration
1 ).
4 4
).
2
).
3
on page 4 ).
on page 11 for
16