Single Ec 200 Configuration; Setup Overview; Single Vnm Ec 200 Configuration - Extron electronics VNM EC 200 User Manual

Single EC 200
Configuration
This section details basic information needed to configure the settings of a single
VNM EC 200. For information on how to set up redundant VNM EC 200s, see
(Redundant) Controller Configuration
This section provides information on:
•
•
•
•
NOTE: For additional configuration information, see

Setup Overview

1.
2.
3.
4.
5.
6.
7.
8.
Single VNM EC 200 Configuration
This section details procedures on how to set up and configure a single VNM EC 200
(see
information).
Setup Overview
Single VNM EC 200 Configuration
Configuring a Single EC 200 as the System Controller
Configuring the VN‑Matrix Devices
Configuration on page 19.
Use a network switch to connect the primary VN-Matrix network to the rear panel
Ethernet connector (LAN A) of the VNM EC 200 (see
page 8).
Power on the VNM EC 200, all VN-Matrix devices present in the system, and all
necessary devices (see Power Up Procedure
Connect a control PC to the VN-Matrix network and navigate to the Web-based user
interface of the VNM EC 200 (see
page 11).
Configure the settings of the VNM EC 200 (see
page 13).
Configure the VNM EC 200 as the VN-Matrix system controller (see
Single EC 200 as the System Controller
Configure the VN-Matrix system devices (see
page 18).
If necessary, update the license of the VNM EC 200 (see
License Updates on page 182).
Power down the VNM EC 200 (see
configured devices. After a few seconds, power on the VNM EC 200 and all necessary
devices.
Advanced Controller Configuration
on page 161.
Advanced Controller
Rear Panel Features
on page 10).
Accessing the Web‑based User Interface
Single VNM EC 200 Configuration
on page 17).
Configuring the VN‑Matrix Devices
Controller Firmware and
Power Down Procedure
on page 19 for additional configuration
VNM EC 200 • Single EC 200 Configuration
Dual
on
on
on
Configuring a
on
on page 12) and all
13