Setting The Role Of The Primary Ec 200 - Extron electronics VNM EC 200 User Manual

Setting the Role of the Primary EC 200
Use the following procedure to set the role of the redundant primary VNM EC 200 (see
Accessing the Web‑based User Interface
1. Log into the redundant primary VNM EC 200 using the designated IP address and
click the Configuration tab.
The Configuration page opens (see figure 157,
1 1
2 2
Figure 157.
2. Under Device Properties, click the Role link (see
3. From the Device Mode drop-down list, select redundant_primary (
NOTE: For information on the other device modes, see
4. Click Apply Changes to save the configuration (
NOTES:
•
•
Configuration Page — Redundant Primary Role Setup
The Web-based user interface returns to the Login page after saving the
configuration. This may take a few seconds.
After completing this procedure, the
Test Page
(see page 172) are available under a new Cluster Properties
folder on the left panel of the Configuration page.
VNM EC 200 • Dual (Redundant) Controller Configuration
on page 11).
).
1
3 3
4 4
).
2
Role Page
).
4
Cluster Page (see page 175) and
).
3
on page 22.
Node
164