Adding The Vnm Ec 200S To The Controller List - Extron electronics VNM EC 200 User Manual

Adding the VNM EC 200s to the Controller List
Use the following procedure to add the VNM EC 200s to the controller list (see
the Web‑based User Interface
1. Log in to the redundant primary VNM EC 200 and click the Configuration tab.
The Configuration page opens (see figure 162,
1 1
2 2
Figure 162.
2.
Click the System config link (
3. In the Controllers field, click Add (
4. Enter the cluster IP address of the VNM EC 200 pair into the dialog box (not shown) and
click OK.
NOTE: If necessary, clear the Controllers field. Highlight the IP addresses and
click Delete.
5. Click Apply Changes to save the configuration (
The VNM EC 200 restarts the user interface and is assigned as the system controller.
6. Log in to the redundant secondary VNM EC 200 and repeat this procedure.
on page 11).
3 3
Configuration Page — Adding Controllers to the Controller List
).
2
3
VNM EC 200 • Dual (Redundant) Controller Configuration
).
1
4 4
).
).
4
Accessing
169