Setting The Role - Extron electronics VNM EC 200 User Manual

6. Configure the IP address of the control PC so that it is within the address range of the
VNM EC 200.
NOTE: Complete this step only if the IP address of the VNM EC 200 is using
a network prefix other than 192.168.254.xxx or subnet mask other than
255.255.255.0.
7.
If necessary, restart the control PC to save the configuration.

Setting the Role

Use the following procedure to set the role of the VNM EC 200. See
Web‑based User Interface
1. Click the Configuration tab. The Configuration page opens (see figure 12,
2 2
Figure 12.
2. Click the Role link (
3.
From the Device Mode drop-down list, select singleton (
NOTE: For information on the other device modes, see
4. Click Apply Changes (
NOTE: The Web-based user interface returns to the login page after saving the
configuration.
on page 11 for login information.
1 1
3 3
Configuration Page — Single VNM EC 200 Role Setting
).
2
).
4
).
3
Role Page
VNM EC 200 • Single EC 200 Configuration
Accessing the
1 ).
4 4
on page 22.
15