At+Cgpsnmea Configure Nmea Sentence Type - SimCom SIM7500 Series At Command Manual

Test Command
AT+CGPSAUTO=?
Read Command
AT+CGPSAUTO?
Write Command
AT+CGPSAUTO=<auto>
Defined values
<auto>
0 – Non-automatic
1 – automatic
Examples
AT+CGPSAUTO=1
OK
17.8

AT+CGPSNMEA Configure NMEA sentence type

Description
This command is used to configure NMEA output sentences which are generated by the gpsOne
engine when position data is available.
NOTE: If nmea bit 2 GPGSV doesn't configure, GPGSV sentence also doesn't output on
AT/modem port even set AT+CGPSFTM=1.
SIM PIN References
NO Vendor
Syntax
Test Command
AT+CGPSNMEA=?
Read Command
AT+CGPSNMEA?
Write Command
AT+CGPSNMEA=<nmea>[,
SIM7500_SIM7600 Series_AT Command Manual_V1.07
Responses
+CGPSAUTO:( list of supported <auto>s)
OK
Responses
+CGPSAUTO:<auto>
OK
Responses
OK
ERROR
Responses
+CGPSNMEA: (scope of <nmea>),(scope of <bdnmea>)
OK
Responses
+CGPSNMEA: <nmea>,<bdnmea>
OK
Responses
OK
Smart Machine Smart Decision
376 2017-12-25