At+Cgsms Select Service For Mo Sms Messages - SimCom SIM7500 Series At Command Manual

+CBM:
<ds> （not used in CDMA/EVDO mode）
0 – No SMS-STATUS-REPORTs are routed to the TE.
1 – SMS-STATUS-REPORTs are routed to the TE using unsolicited result code:
+CDS:
+CDS:
2 – If SMS-STATUS-REPORT is stored into ME/TA, indication of the memory location is
routed to the TE using unsolicited result code: +CDSI: <mem3>,<index>.
<bfr>
0 – TA buffer of unsolicited result codes defined within this command is flushed to the TE
when
1 – TA buffer of unsolicited result codes defined within this command is cleared when
<mode> 1 to 3 is entered.
Examples
AT+CNMI?
+CNMI: 0,0,0,0,0
OK
AT+CNMI=?
+CNMI: (0,1,2),(0,1,2,3),(0,2),(0,1,2),(0,1)
OK
AT+CNMI=2,1 (unsolicited result codes after received messages.)
OK
7.10

AT+CGSMS Select service for MO SMS messages

Description
The write command is used to specify the service or service preference that the MT will use to send
MO SMS messages.
The test command is used for requesting information on which services and service preferences can
be set by using the
The read command returns the currently selected service or service preference.
Note: This command not support in CDMA/EVDO mode
SIM PIN References
YES 3GPP TS 27.007
Syntax
Test Command
AT+CGSMS=?
SIM7500_SIM7600 Series_AT Command Manual_V1.07
<sn>,<mid>,<dcs>,<page>,<pages><CR><LF><data>
<length><CR><LF><pdu>
<fo>,<mr>,[<ra>],[<tora>],<scts>,<dt>,<st>
<mode> 1 to 3 is entered (OK response shall be given before flushing the codes).
AT+CGSMS write command
Responses
+CGSMS: (list of supported <service>s)
OK
(PDU mode enabled); or
(text mode enabled)
165
Smart Machine Smart Decision
(text mode enabled)
2017-12-25