At+Stkfmt Set Stk Pdu Format - SimCom SIM7500 Series At Command Manual

SIM PIN References
NO Vendor
Syntax
Test Command
AT+STK=?
Read Command
AT+STK?
Write Command
AT+STK=<value>
Execution Command
AT+STK
Defined values
<value>
0 – Disable STK
1 – Enable STK
Examples
AT+STK=1
OK
11.5

AT+STKFMT Set STK pdu format

Description
This command is used to disable or enable the STK pdu mode. If the argument is 1, it is enabled.
While if the argument is 0, it is disabled.
NOTE: Module should reboot to take effective.
SIM PIN References
YES Vendor
Syntax
Read Command
SIM7500_SIM7600 Series_AT Command Manual_V1.07
Responses
+STK: (list of supported <value>s)
OK
Responses
+STK: <value>
OK
Responses
OK
ERROR
Responses
Set default value (<value>=0):
OK
Responses
Smart Machine Smart Decision
243 2017-12-25