Danfoss MCO 305 Design Manual page 95

MCO 305 Design Guide
CAM Commands
Commands for the synchronization in CAM-Mode (CAM control).
Command Description
CURVEPOS Retrieve slave curve position that
corresponds to the current master
position of the curve
DEFMCPOS define initial position of the master
POSA CURVEPOS move slave to the curve position
corresponding to the master position
SETCURVE set CAM curve
SYNCC synchronization in CAM-Mode
SYNCCMM synchronization in CAM-Mode with
master marker correction
SYNCCMS synchronization in CAM-Mode with
slave marker correction
SYNCCSTART start slave for synchronization in CAM-
Mode
SYNCCSTOP stop slave after the CAM
synchronization
__ Software Reference __
Syntax
res = CURVEPOS
DEFMCPOS p
POSA CURVEPOS
SETCURVE array
SYNCC num
SYNCCMM num
SYNCCMS num
SYNCCSTART pnum
SYNCCSTOP pnum
slavepos
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
Parameter
–
p = position in MU
–
array = array or curve name
num = number of curves to be
processed (0 = drives
remains in CAM mode)
as above
as above
pnum = start stop points number
pnum = start stop points number
slavepos = slave position after
disengaging
95