Danfoss MCO 305 Design Manual page 182

MCO 305 Design Guide
MCO Parameters
For a better overview the MCO Parameters are divided into groups:
32-** MCO Basic Settings
32-0* Encoder 2 - Slave
32-3* Encoder 1 - Master
32-5* Feedback Source
32-6* PID controller
32-8* Velocity & Acceleration
33-** MCO Advanced Settings
33-0* Home Motion
33-1* Synchronization
33-4* Limit Handling
33-5* I/O Configuration
34-** MCO Data Readouts
34-0* PCD Write Parameters
34-2* PCD Read Parameters
34-4* Inputs & Outputs
34-5* Process Data
General Information on the Parameter Values
Some limiting values are listed at 1 billion to make them more easily readable. However, the exact value is
1,073,741,823. (= MLONG).
Input Range
Whether the input range listed is exceeded is not checked by the program, since due to the large domain
there are no suitable test possibilities.
NB!:
Even within the areas indicated illogical inputs can result from the large differences in performance
of the motors and the wide variety of possible applications. Therefore, it is the responsibility of the
programmer and the user to observe the performance ranges of the drive and of the system.
NB!:
If the value of the parameter is out of the range defined by the minimum and maximum value the
command is not displayed and executed correct.
default setting
182
__ Parameter Reference __
[ ] value for use in communication via serial communication port
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
page 183
page 184
page 188
page 189
page 191
page 193
page 194
page 204
page 205
page 211
page 211
page 211
page 212
page 212