Danfoss MCO 305 Design Manual page 236

MCO 305 Design Guide
Index Name
10 IndexFIP
11 IndexINP
12 IndexSTPInd
13 IndexSTPVel
14 IndexSTIP
15 IndexSTPIP
Curve Information
1 MasterCycleLen
2 SlaveCycleLen
3 FixPointNo
4 InterpolPointNo
5 InterpolType
6 SlaveStopPosition
7 CorrectionStartPoint
8 CorrectionStopPoint
9 MaximumCorrection
10 MaxStartStopLen
11 StartStopNo
12 MMaxCycles
13 MMarkerPos
14 SMarkerPos
Start/Stop Point
1 STPoint_1.a
2 STPoint_1.b
3 STPoint_2.a
4 STPoint_2.b
5 ...
6 ...
2*n-1 STPoint_n.a
2*n STPoint_n.b
236
__ Appendix __
Unit Value
(dec) IndexSTP +
STPno*2
(dec) IndexFIP +
FixPointNo * 3
(dec) IndexINP +
InterpolPointNo
(dec) IndexSTPInd
+STPno*2
(dec) IndexSTPVel
+STPno*2
(dec) IndexSTIP +
MaxStartStopLen
MU -
UU -
(dec) 4
(dec) -
(dec) 0
UU 0
MU 0
MU MasterCycleLen
UU -
(dec) 0
(dec) 0
(dec) 0
CM 0
CS 0
MU 0
MU 0
MU 0
MU 0
MU 0
MU 0
MU 0
MU 0
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
Description
Index to Fix point Part
Index to Interpolation Point Part
Index to StartStop Interpolation Indices
Index to StartStop Velocities
Index to Startpath interpolation points
Index to Stoppath interpolation points
Length of Curve in CurveMaster units
Slave max. travel distance in CurveSlave units
Number of fix points (minimum 4)
Number of interpolation points (including first
and last, which correspond to the same
location)
0 = cubic spline, 1 = periodic cubic spline
Position, where slave stands after stopping
Position, where Correction may start
Position, where Correction has to be finished
Maximum Correction which is allowed in one
cycle
Maximum length of start/stop path (no of int.
points)
Number of start stop point pairs (n) (see below)
Max. number of cycles per minute (application
info)
Master Marker Position in curve
Slave Marker Position in curve
Start (forward) / Stop (backward) point no. 1
Stop (forward) / Start (backward) point no. 1
Start (forward) / Stop (backward) point no. 2
Stop (forward) / Start (backward) point no. 2
Start (forward) / Stop (backward) point no. n
Stop (forward) / Start (backward) point no. n