Danfoss MCO 305 Design Manual page 221

MCO 305 Design Guide
Troubleshooting
Warnings and Error Messages
All messages are shown in the LCP display of the FC 300 in short and in the APOSS software in plain text.
You can find brief information on the error messages in the table or detailed information in the following
section.
The tables contain the messages in numerical order. Letters following a % sign represent variables which
can be used in plain text at the corresponding locations.
Error Error text
no.
103 Illegal axis num.
105 Error not reset
106 Home not done
107 Home vel. zero
108 Position error
109 Index not found
110 Unknown cmm.
111 SW end limit
112 Unknown param.
113 FC not enabled
114 Too many loops
115 Par. save failed
116 Param. memory
117 Progr. Memory
118 Reset by CPU
119 User abort
125 HW end limit
Description
Axes not in system.
Error not cleared.
Failed to move to HOME position.
Home was executed with Home Velocity set to zero.
Position error.
Index pulse (encoder) not found.
Unknown command.
Software end limit activated.
Illegal parameter number.
FC 300 is not ready but the PID controller is active.
Too many nested loops.
Parameters save failed.
Parameters in memory are corrupted.
Programs in memory are corrupted.
Reset by CPU.
User abort.
HW end limit activated.
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
221