Danfoss MCO 305 Design Manual page 61

MCO 305 Design Guide
Position Drive
Or you can use the teach-in function and click on
Position drive: in the dialog field the actual position
of the axis is displayed. Click on the forwards > or
on the backwards < symbol and move the drive to
the position desired. This can be done either step-
by-step, with individual mouse clicks, or with conti-
nuous movement by holding the mouse button
depressed.
Once the drive has reached the desired position,
click on Accept and the value is entered in the
dialog field for the axis.
Select Controller
If you have configured more than one FC 300, then
use Development Select controller to select the
FC 300 that you want to use to load and start the
programs. All currently available controllers will be
displayed in a tree view. Select the desired control-
ler and click on OK to connect to that controller. If
no controllers are shown or the desired interface is
not present, then select the desired interface from
the Interface dropdown box and click on
Interface.
Run programs in several FC 300s
If you want to load the program into several con-
trollers, link the program with the corresponding
FC 300 and click on Execute.
If you want to load a different program in each
controller, open a different edit window for each
FC 300, then open the desired program file and
connect it to the FC 300 with
Then start each program, one after the other, with
Execute.
Close Interface
When this menu item is selected, if there is a currently open motor controller interface, then it is closed.
If there is no open interface, then the menu item has no effect.
__ PC Software Interface __
Open
Select controller.
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
61