Danfoss MCO 305 Design Manual page 229

MCO 305 Design Guide
File name or
topic
Online
help
x
ORIG_01.M
x
OUT_01.M
x
OUTB_01.M
x
POS_01.M
x
Position
Synchronizing
x
Relative
Positioning
x
REPEA_01.M
x
slavesync.m
x
stamping.m
x
STAT_01.M
x
syncc_msim.m
x
TORIG_01.M
x
Touch Probe
Positioning
x
Velocity
Synchronizing
x
VEL_01.M
x
WAIT_01.M
x
WHILE_01.M
__ Appendix __
Where to find? Description
Manual or
Software
Searching the real zero point after a continuous motion in speed
mode.
Sets some outputs according to the current position.
Copy the status of every input to the corresponding output.
Relative and absolute positioning.
Design Guide Position Synchronizing for "Packaging with Fixed Product Distances"
page 28 application sample.
Design Guide Relative Positioning for "Palletizer" application sample.
page 21
Counts down 10 seconds and starts a continuous motion.
APOSS Software CAM Control: Slave Synchronization with Marker
APOSS Software CAM Control: Stamping of Boxes with Use-by Date
Reads in and displays some system information.
Simulation of a master via software command.
Defines different temporary zero points and shows what it means to
the current position information.
Design Guide Touch Probe Positioning for "Palletizer" application
page 23
Design Guide Velocity Synchronizing for Suit Case Conveyor Belt application.
page 25
Varies the velocity during a position-controlled motion.
Demonstrates some types of waiting: time delay wait until target
position is reached wait for a defined input condition.
Waits for an high signal on input 4 and displays all memorized
inputs, made via the COM-interface during this time.
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
229