Danfoss MCO 305 Design Manual page 16

MCO 305 Design Guide
__ Introduction to VLT Motion Control Option MCO 305 __
A temporary program can be executed from the program editor (MCT10/APOSS), temporary programs are
only stored in RAM and are thus lost at power-down. The temporary program can also be executed in a
special Debug mode where it is possible to influence the program execution as well as reading out data and
variables, see on-line help of APOSS for further details.
When connecting a PC with MCT 10 to the drive, the active program might be aborted e.g. when
downloading a new program or when working with the program editor ([Esc] will abort program
execution).
NB!:
In case of an error the active program will be terminated if no error handler (ON ERROR GOSUB
xxxx) is defined and the program will not be restarted.
16
®
MG.33.L4.02 – VLT is a registered Danfoss trademark