Danfoss MCO 305 Design Manual page 65

MCO 305 Design Guide
Reset Parameter
If you want the standard settings for all parameters, simply click on Controller
NB!:
The global and I/O parameters will also be reset to the default settings if you do this.
Parameters > Name
You can also enter a name for each FC 300 in addition to the number or change an existing name with this
function. Click on Controller
(no longer than 8 characters) or overwrite the existing name and click on OK.
Parameters > Save to File and > Restore from File
Save with Parameters
This way you can quickly load the parameters in another FC 300 or re-load them in the FC 300 at any sub-
sequent time, for example after deleting the EEPROM.
Select the controller and then click on
file name. The suggested filename contains the date and time to be safe from overwriting actual files in
case of restoring from file. If the parameters of multiple controllers are to be saved, then simply select
another controller and
Click on Parameters Restore from file and select the file containing the data to be loaded. In the sub-
sequent dialog, select the controller in which the data should be loaded and then click the
button. The parameters saved, including the arrays, are immediately loaded in the controller.
If the same data is to be loaded into more than one controller, then simply select another controller and
click Restore again.
Controller > Memory
Additional to Save RAM and
there are functions to save individually data in the
LCP memory for example
Memory > Save RAM
The function Save RAM is usually not needed since the programs and parameters are automatically saved.
But with Save RAM you can also save the current array values in the EEPROM. Save RAM corresponds to
the command SAVEPROM, since all programs, parameters and arrays are saved.
Memory > Delete EEPROM
Delete the EEPROM in the LCP if you either want to undo the array definition or want to re-set all
parameters to the default settings.
NB!:
When you delete the EEPROM all parameters are reset to the factory settings. However, this is only
done after the FC 300 has been turned off.
__ PC Software Interface __
Parameters Name and select the FC 300, enter a name in the field Name
Save to file the parameters including the arrays in a file with the extension ".CNF".
Save. Enter a name in the subsequent dialog field or confirm the
Save again.
Delete EEPROM
Option Parameters.
®
MG.33.L4.02 – VLT is a registered Danfoss trademark
Reset Parameters.
Restore
65