Table of Contents
Advertisement
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel to the system.
Figure 24. Installing the left control panel
Next steps
1.
Install the drive backplane
2. If removed,
install the air
3. Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the front
4.
Remove the backplane
5. If installed,
remove the air
6. Disconnect the VGA cable from the connector on the system board and open the cable latch.
7. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the
system.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
cover.
shroud.
After working inside your system
Safety instructions
Before working inside your system
bezel.
cover.
shroud.
on page 26.
on page 25.
on page 26.
Installing and removing system components
35
Advertisement
Table of Contents
