Table of Contents
Advertisement
Figure 84. Installing the USB memory key
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the front
bezel.
4.
Remove the backplane
5.
Remove the air
shroud.
6. Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
and connecters
section.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips #1 screwdriver, remove the screw on the VGA module.
2. Slide the module out of the system.
94
Installing and removing system components
After working inside your
Safety
instructions.
Before working inside your
cover.
system.
system.
System board jumpers
Advertisement
Table of Contents
