Table of Contents
Advertisement
Figure 22. Installing the left control panel
Next steps
1.
Install the drive backplane
2. If removed,
install the air
3. Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the front
4.
Remove the backplane
5. If installed,
remove the air
6. Disconnect the VGA cable from the connector on the system board and open the cable latch.
7. Disconnect the right control panel cable from the system board and move it away to see the VGA module screw on the system.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
Steps
1. Using Phillips #2 screwdriver, remove the screw on the VGA module.
2. Slide the VGA module out of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
cover.
shroud.
After working inside your
Safety
instructions.
Before working inside your
bezel.
cover.
shroud.
system.
system.
Installing and removing system components
49
Advertisement
Table of Contents
