Expander Module; Removing The Expander Module; Installing The Expander Module - Dell EMC PowerEdge xe7100 Installation And Service Manual

Expander module

Removing the expander module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in the
Steps
1. Loosen the captive screw.
2. Pull the expander module handle from under the expander module.
3. Using expander module pull handle, slide the expander module out of the enclosure horizontally.
Figure 31. Removing the expander module
Next steps
1. Install the expnader module.

Installing the expander module

Prerequisites
1. Follow the safety guidelines listed in
Steps
1. Align and slide the expander module into the chassis.
2. Push the expander module pull handle.
3. Tighten the captive screw.
NOTE: Ensure both the expander modules are installed completely before powering up the chassis.
36 Installing and removing enclosure components
safety instructions.
Before working inside your
safety instructions.
system.