Table of Contents
Advertisement
Steps
Route the USB cable on the USB module, through the USB slot on the front panel.
Insert the USB module into the slot on the front panel.
Align the screw on the module with the screw hole on the system.
Using the Phillips #1 screwdriver, replace the screw to secure the module to the system.
Route the USB cable and connect it to the USB connector on the system board. For more information, see the System board jumpers
and connecters section.
Figure 112. Installing the USB module
Next steps
Install the air
shroud.
Install the backplane
cover.
Follow the procedure listed in
VGA module
Removing the VGA module
Prerequisites
Follow the safety guidelines listed in
Follow the procedure listed in
Remove the front bezel
Remove the backplane
cover.
Remove the air
shroud.
Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
and connecters
section.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route these cables
properly when you replace them to prevent them from being pinched or crimped.
Steps
Using Phillips #1 screwdriver, remove the screw on the VGA module.
After working inside your
system.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
System board jumpers
149
Advertisement
Table of Contents
