Radioavailfreq; Radiochanmask; Radioenable; Radiohopseq - Campbell CR300 Series Product Manual

23.3.60.1 RadioAvailFreq

Displays the bitfield of the frequencies that are available in the module's region of operation.
String data type
l
Read only
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Available Frequencies
l

23.3.60.2 RadioChanMask

The channel mask allows channels to be selectively enabled or disabled. This allows you to avoid
using frequencies that experience unacceptable levels of RF interference.
String data type
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio Channel Mask
l

23.3.60.3 RadioEnable

Global control for the internal radio module.
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > Radio Enable
l

23.3.60.4 RadioHopSeq

Specifies the radio channel hop sequence. This setting must match in all radios in the same RF
network. This setting can also be used to prevent radios in one RF network from listening to
transmissions of another.
Long data type
l
Where to find:
Settings Editor tab in Device Configuration Utility: Radio > RF Hop Sequence
l
23. Information tables and settings (advanced) 229