Dräger Infinity Acute Care System M540 Instructions For Use Manual page 171

SpO parameter box (Masimo SET MCable)
2
The SpO parameter box contains the following el-
2
ements:
A B
J
A SpO label
2
B Units of measure
C Crossed triangle symbol when the SpO
is turned off.
D PLS (pulse) label
E PLS value
F Crossed triangle symbol when the PLS alarm is
turned off.
G Perfusion index value
H Perfusion index label
I Pulse bar graph — can be turned on/off (see
page 173)
J SpO saturation value
2
K Upper and lower limit
PLS CO-Ox parameter box (Masimo rainbow
SET MCable)
The PLS CO-Ox parameter box appears in addition
to the regular SpO parameter box when a Masimo
2
rainbow SET MCable is connected that supports
parameters in addition to the standard parameter
set (SpO , PLS, PI). The parameter content of the
2
parameter box is configurable (see page 175).
Instructions for use Infinity Acute Care System – Infinity M540 SW VG4.n
SpO
2
F
C D E
100
85
I
H G
K
alarm
2
and Pulse CO-Ox monitoring with Masimo SET MCable
The display of PLS CO-Ox parameters
(SpHb/SpHbv, SpOC, SpMet, PVI, SpCO) is af-
fected by the following conditions:
– Blanks appear instead of parameter values if a
sensor is connected but the parameter is not
activated on the MCable.
– Asterisks (***) replace the parameter values un-
der the following circumstances:
– A parameter is activated but an incompati-
ble sensor is connected
– A parameter is activated but no sensor is
connected
– A technical failure exists (for example, an
unplugged sensor)
NOTE
The parameter SpHb changes to SpHbv (if
Venous was selected for the blood source setting
SpHb Cal – see page 177).
171