Siruba LKS-1900AN Instruction Book page 70

(2) 縫製開始緩啟動速度的設定
縫製開始的第 1 針～第 5 針的速度可以以
100sti/min 為單位進行設定。可以設定為有
夾線和沒有夾線。 （參照「Ⅰ .[8]-3. 記憶
體開關功能一覽表」 P .55）
有夾線時單位 ：sti/min
第 1 針 1st stitch
第 2 針 2nd stitch
第 3 針 3rd stitch
第 4 針 4th stitch
第 5 針 5th stitch
注意 : 最高轉速、記憶體開關 No.1（最高速度
限制）優先。
設定例 ：有夾線時，變更為第 1 針 1500 →
1000sti/min、第 2 針 3200 → 2000sti/min。
1）縫製 LED 滅燈的狀態下，按
Press key in the state that the sewing
1）
LED is put out.
2）用
鍵、
No.2。這裡設定第 1 針的縫紉機速度。
2）Indicate memory switch No. 2 with
key.Here, set the sewing speed of the
first stitch.
3）按 鍵。縫製 LED 亮燈，第 1 針的設定
值被顯示出來。
3) Press key. The sewing LED lights
up and the set value of the first stitch is
indicated.
P51
出貨狀態
State when delivered
1500
3200
3200
3200
3200
鍵。
鍵顯示出記憶體開關
or
(2) Setting the soft start speed at the sewing
start
The speed of the first stitch to the fifth
stitch at the sewing start can be set in a
unit of 100 sti/min. Two kinds of settings,
in case of with needle thread clamp and
of without needle thread clamp can be
performed. (See " Ⅰ .[8] -3. Table of
functions of the memory switch" p.55.)
In case of with needle thread clamp Unit :
sti/min
Setting range
400 ～ 1500
400 ～ 3200
400 ～ 3200
400 ～ 3200
400 ～ 3200
Caution
:For the max. sewing speed, the
memory switch No. 1 (max. sewing speed
limitation) has priority.
Setting example : In case of with needle
thread clamp, the speed is changed as
follows.1st stitch from 1,500 to 1,000 sti/min
and 2nd stitch from 3,200 to 2,000 sti/min.
設定範圍