Siruba LKS-1900AN Instruction Book page 62

3. 壓腳的高度
⑴ 在停止狀態，卸下 6 根機架外罩固定螺
絲①然後卸下機架外罩②。
⑵ 把 L 形扳手③插入中央的緊固筒④的六
角孔螺栓⑤，把它放鬆 。
⑶ 把 L 形扳手③向下壓布壓腳升高，向上
抬布壓腳降低。
⑷ 調節後，把六腳孔螺栓⑤確實鎖緊。
⑸ 左右壓腳不一致時，放鬆固定螺絲⑥，
調節布壓腳撥桿擋板⑦調整高度。
警告
WARNING
注意 : 此時，請不要讓布壓腳撥桿擋板 ⑦與送布台⑧相碰。如果和挑線桿相碰，請用挑線
桿安裝台固定螺絲⑨調節挑線桿高度。
Caution
:At this time, be careful not to cause work clamp foot lever support plate
⑦ to interfere with feed bracket ⑧ .If the work clamp foot lever support plate
interferes with the wiper, readjust the height of the wiper using setscrew ⑨ in
the wiper installing base.
P43
為了防止意外的起動造成人身事故，請關掉電源後再進行操作。
As the work is performed while the power is ON, never touch the switches
other than the necessary one so as to prevent accidents caused by the
malfunction of switches.
①
③
⑨
最大Max.17mm
3. Adjusting the lift of the work clamp foot
⑴ With the machine in stop mode, remove
six setscrews ① of the top cover, and
take off top cover ② .
⑵ Apply L-shaped wrench ③ to socket bolt
⑤ of clamp ④ , and loosen the socket
bolt.
⑶ Push down L-shaped wrench ③ to
increase the lift of the work clamp foot,
or pull it up to decrease the lift.
⑷ After the adjustment, securely tighten
socket bolt ⑤ .
⑸ If the right and left work clamp feet are
not levelled, loosen fixing screw ⑥ and
adjust the position of the work clamp
foot lever support plate ⑦ to level them.
④
②
⑤
⑦
⑧
⑥