Siruba LKS-1900AN Instruction Book page 44

⑵ 光捲繞底線時
1）按 鍵，讓縫製 LED 滅燈。
2）按
鍵，選擇卷線
※ 注意 : 如果縫製 LED 亮燈時不能選擇。
3）按 鍵。壓腳下降，縫製 LED 亮燈。
4) 踩踏踏板開關之後，縫紉機開始轉動。
5）再次踩踏板，或者按
之後縫紉機停止轉動。
6）按 鍵之後，縫製 LED 滅燈，壓腳
上升，
注意 : 剛剛打開（ON）電源後，卷線不動作。請設定 1 次圖案 No. 等，按
LED 亮燈之後再進行操作。
Caution
:Bobbin winder does not work immediately after turning ON the power. Perform
the bobbin winding after setting pattern No.or the like once, pressing the
key,and making the sewing LED light up.
P25
。
鍵、
鍵變為有效。
⑵ To wind a bobbin independently
1) Press
LED go off.
2) Select the bobbin winder
key.
Caution
※
when the Sewing LED is lit up.
鍵
3) Press
come down and the Sewing LED lights
up.
4) When the pedal switch is depressed,
the sewing machine rotates.
5) When the pedal is depressed again,
or
sewing machine stops.
6) When
LED goes off, the work clamp feet go
up and




key to make the SEWING
with
:Selection cannot be performed
key. The work clamp feet
key or key is pressed, the
key is pressed, the Sewing
key becomes effective.
鍵讓縫製