Siruba LKS-1900AN Instruction Book page 43

4. 變更為其他圖案
鍵，縫製 LED 滅燈。
⑴按
鍵，選擇圖案 No.
⑵按
鍵設定圖案 No.。
⑶用 、
⑷同樣地設定 XY 擴大縮小率、轉速等。
鍵之後，縫製 LED 亮燈，成為可
⑸按
以縫製的狀態。
選擇圖案後，請一定確認圖案的形狀。
萬一圖案遠離壓腳，縫製途中機針會碰到壓腳，弄斷機針。
Make sure without fail of the contour of the sewing pattern after selection of
警告
the sewing pattern.
If the sewing pattern extends outside the work clamp feet, the needle
WARNING
will interfere with the work clamp feet during sewing, causing dangerous
troubles including needle breakage.
5. 捲繞底線
⑴邊縫製邊捲繞底線時 : 如圖所示穿線捲繞
底線。
4. Change to the other sewing pattern
⑴ Make the Sewing LED go off with
的項目。
⑵ Press
⑶ Set the pattern No. with
⑷ Similarly, setting of X/Y scale, speed,
⑸ When


5. Winding a bobbin
⑴ To wind a bobbin while the sewing
Introduction
key.
key and select the item of
pattern No .
key.
etc. is performed.
key is pressed, the Sewing
LED lights up and the sewing machine is
in the sewing ready state.
machine is performing sewing:Thread
the bobbin winder and wind the bobbin
thread onto the bobbin as illustrated in
the figure.
key or
P24