Siruba LKS-1900AN Instruction Book page 50

8）按
鍵之後，變為「Y 擴大縮小率
顯示 0.0。Y 方向的移動量可以以 0.1mm 為
單位進行設定。用
為 -1.0。
8）Press key and"Y Scale rate
＂indication becomes 0.0. Traveling amount
in Y direction can be set in 0.1 mm unit. Set
–1.0 with or
9）按
鍵之後，設定結束。
9）Press key to finalize the setting.
10）按
鍵。結束圖案登記方式。
10）Press key.Pattern register mode is
finalized.
11）按
鍵。 結束方式設定，返回待機方式。
11）Press key.Mode setting is finalized and the mode returns to the normal mode.
⑵縫製操作
操作例 ：先以登記的 P2 內容進行縫製，然
後縫製 P3 的內容。
1）打開電源。
2）按
鍵。
3）按 鍵，縫製 LED 亮燈後，壓腳移
動上升。
4）確認圖案形狀。（請參照「Ⅰ .[5]-2. 圖
案形狀的確認 P .22 之項。）
5）如果圖案形狀正確，則可以縫製。
6）縫製結束後，按
索原點後，移動到縫製開始點，然後壓
腳上升。（P 鍵在縫制 LED 亮燈時，也
可以按鍵變換圖案。）
P31
」
鍵、 鍵設定
key.
鍵，壓腳下降，檢
(2) Sewing operation
Operation example : After performing
sewing with the contents of the registered
P2, perform sewing with the contents of
P3.
1) Turn ON the power switch.
2) Press the key.
3) Press the key, and when the
sewing LED lights up, the work clamp
foot goes up after it has moved.
4) Check the contour of the sewing
pattern.(Refer to the item " Ⅰ .[5]-
2. Checking the contour of a sewing
pattern" p.22.)
5) If the contour of the sewing pattern is
acceptable, the sewing can be made.
6) Press key after completion of
sewing and the presser comes down.
The presser moves to the sewing start
point after origin retrieval and goes up.
(The P keys can operate the pattern
chage by onetouch even when the
sewing LED is lighting up.)