Siruba LKS-1900AN Instruction Book page 14

5. 變更圖案、準備鍵 ON 、壓腳開關 ON 、中
壓腳按鈕 ON 、繞線按鈕 ON 時，壓腳自動
地下降， 為了防止突然的啟動發生的事故，
請絕對不要把手指放到壓腳下面。
6. 為了防止捲入機器的人身事故，縫紉機運轉
中請不要把手指、頭髮、衣服靠近馬達、切
刀等驅動部分，也不要把物品放到機器的上
面。
7. 為了防止對人身的傷害，請不要在卸下馬達
外罩、護目鏡等安全裝置的狀態下運轉縫紉
機。
8. 為了防止人身傷害，卸下縫紉機各部的護罩
的狀態下，請不要運轉縫紉機。
9. 操作盤上也進行有關安全的警告，打開 ( ON
) 電源後請確認了機器正常之後再運轉縫紉
機。
10. 為了防止人身傷害，縫紉機運轉中請不要用
手按推皮帶飛輪。
11. 為了防止對人身的傷害，放倒縫紉機時和返
回原來位置時，請注意不要夾到手指等。
12. 為了防止觸電和損壞電氣零件的事故，插拔
電源插頭之前請一定關掉電源開關。
13. 為了防止損壞電氣零件的事故，打雷時，請
停止作業，拔下電源插頭，以保證安全。
14. 為了防止損壞電氣零件的事故，從寒冷的地
方移動到暖和的地方等時，容易發生結露現
象，所以請待水滴完全乾燥之後再打開電源。
5. Feeding frame automatically comes down
when pattern is changed, ready key is ON,
Presser switch is ON, intermediate presser
button is ON and bobbin winder button is
ON. To prevent possible accidents caused
by abrupt start of the sewing machine,
never place your finger under the feeding
frame.
6. To avoid personal injury, never bring
your fingers hair or clothing close to V
belt, cloth cutting knife or motor during
operation, and never place anything on
any of these parts.
7. To avoid personal injury, never operate
the machine with the motor cover, eye
protection cover, or any other safety
devices removed.
8. To prevent personal injury or death, do not
operate the sewing machine with its covers
removed.
9. The operation panel displays safety
warnings. It is necessary therefore to first
verify normal display on the panel when
the power switch is turned on, before
operating the sewing machine.
10.To prevent personal injury or death, do not
press the hand pulley while the sewing
machine is in operation.
11.To avoid personal injury, be careful never
to allow your finger to go inside the
machine when tilting or raising the machine
head.
12.To prevent possible accidents due to
electric shocks or damaged electrical
component(s), always turn OFF the power
switch before connecting or disconnecting
the power plug.
13.During thunder and lightning storms, stop
your work and disconnect the power from
the outlet to ensure safety and prevent
possible accidents due to damaged
electrical component(s).
14. If the machine is suddenly moved from
a cold place to a warm place, dew
condensation may result.If this occurs,
be sure to confirm that there are no
potentially dangerous water drops in
the machine before turning it on in order
to prevent possible accidents due to
damaged electrical component(s).