Siruba LKS-1900AN Instruction Book page 65

8. 旋梭的加油量
⑴ 放鬆固定螺絲①，卸下固定螺絲①。
⑵ 鎖緊調整螺絲②之後，加油管左④的油量
被弄小。
⑶ 調整後，鎖緊固定螺絲①固定好。
注意 :1. 在標準出貨狀態，輕輕鎖緊③回轉 4 圈的位置。
2. 弄小油量時，不要一次鎖緊，鎖緊③回轉 2 圈，待半日左右觀看一下。鎖得過緊
的話會磨損旋梭油管。
Caution
:1.The state of standard delivery is the position where ③ is lightly screwed in
and returned by 4 turns.
2.When reducing the amount of oil, do not screw in the screw at once.Observe
the state for approximately half a day at the position where ③ is screwed in
and returned by 2 turns. If reducing is excessive, worn-out of the hook will
result.
9. 保險絲的更換
使用 3 個保險絲。
①步進馬達電源保護用 5A（延時保險絲）。
②電磁鐵，步進馬達電源保護用 3.15A（延
時保險絲）。
③控制電源保護用 2A（速斷型保險絲）。
1. 為了防止觸電事故，關掉電源 5 分鐘之後再打開外罩。
2. 請一定關掉電源開關之後再打開控制箱的蓋子，更換規定容量的保險絲。
危險
1. To avoid electrical shock hazards, turn OFF the power and open the control
box cover after about five minutes have passed.
DANGER
2. Open the control box cover after turning OFF the power without fail. Then,
replace with a new fuse with the specified capacity.
8. Amount of oil supplied to the hook
⑴ Loosen setscrew ① and remove
setscrew ① .
⑵ When screwing in adjustment screw ② ,
the amount of oil of oil pipe, left ④ can
be reduced.
⑶ After the adjustment, screw in setscrew
① and fix it.
④
③
②
①
9. Replacing the fuse
The machine uses the following three fuses
① For pulse motor power supply protection
② For solenoid and pulse motor power
③ For control power supply protection 2A
Introduction
5A (time-lag fuse)
supply protection 3.15A (time-lag fuse)
(fast-blow type fuse)
①
②
③
P46