Siruba LKS-1900AN Instruction Book page 69

2. 記憶體開關的設定例
(1) 縫製速度上限的設定
設定例 ：把縫製速度的上限設定到 1800sti/
min。
1）在縫製 LED 滅燈的狀態按
記憶體被啟動，顯示記憶體開關 No.1 的內
容。 縫紉機的最高速度限制用記 憶體 No.1
設定， 所以不需要變更，但是可以變換用
鍵顯示的記憶體開關 No.。
鍵、
1) Press key in the state that the sewing
LED is put out.
The memory switch is started and the
contents of memory switch No. 1 are
indicated.It is not necessary to change
the sewing speed since the max. speed
limitation of the sewing machine is set with
memory switch No. 1. The indicated memory
switch No. can be changed over with
or key.
2）記憶體開關 No.1 被顯示的狀態下，按
鍵，點亮縫製 LED。記憶體開關 No.1
的內容（縫紉機的最高速度限制值）被顯示。
2) Press
key in the state that memory
switch No. 1 is indicated to make the
sewing LED light up. The contents of
memory switch No. 1 (max. sewing speed
limitation value of the sewing machine) are
indicated.
3）用
鍵、
3）Set "1800" with
4）按 鍵登記。縫製 LED 滅燈。
Register the value with
4）
5）按
鍵，返回待機狀態。
Press key to return to the normal state.
5）
注意 : 在待機狀態，縫紉機速度不能設定到該值以上。
Caution
:The sewing machine speed in the normal state cannot be increased more than the
value which has been set here.
鍵。
鍵設定為"1800＂。
or key.
key. Sewing LED goes off.
2. Example of the memory switch setting
(1) Setting the max. sewing speed limitation
Setting example : Setting the max. sewing
speed limitation to 1,800 sti/min.
Introduction
P50