Siruba LKS-1900AN Instruction Book page 47

⑷ LKS-1903AN （帶釘扣）時，由於上述 (2)
(3) 的原因，標準出貨狀態時設定為禁止夾
線動作。 （記憶體開關 No.35）有交叉線（
等）、叉形狀（ 等）時，布料背面的上線
容易被捲進，最好使用夾線功能。
⑸使用夾線功能，縫製開始的底線露出布料表
面時，把縫製開始的張力（2 ～ 3 針）降低，
底線就不明顯了。
[ 設定例 ] 縫製張力設定為「35」時，縫製
開始 1 ～ 2 針的張力為「20」。
※ 縫製開始張力的設定，請參照「Ⅰ .[6]-5.
圖案線張力的設定」P .37。
(4) For LKS-1903AN (button sewing),
the thread clamp is set to the motion
prohibited in the state of standard delivery
due to the aforementioned (2) and (3). For
(memory switch No. 35) with crossover
stitch ( , etc.) or X shape (
needle thread on the wrong side of
material becomes easy to be rolled in. In
this case, it is recommended to use the
thread clamp.
(5) When the thread clamp is used, and
bobbin thread at the sewing start appears
on the right side of material, reduce
thread tension at the sewing start (2 to 3
stitches) and bobbin thread becomes less
conspicuous.
[Example of setting] Tension of 1 to 2
stitches at the sewing start is "20＂ when
sewing tension setting is "35＂.
※ For the setting of tension at the sewing
start, refer to 「 Ⅰ . [6]-5. Setting the
pattern thread tension」 p.37
Introduction
, etc.),
P28