Siruba LKS-1900AN Instruction Book page 42

•注意 : 使用縱方向最大長度 ( ＋ 10mm) 的圖
案時，請確認送布台②和挑線桿座①
的間隙。沒有間隙的話，請放鬆固定
螺絲③把挑線桿向針側移動。特別是
機針移動到右側裡面時，間隙應變小。
②
3. 縫製
⑴把縫製品放到壓腳部。
⑵把踏板開關踩到第一級，壓腳下降，腳離
開踏板後，壓腳上升。
⑶把壓腳下降一級，踩到第二級之後開始縫
製。
⑷縫製結束後，壓腳上升返回到始縫的位
置。
P23
•Caution:When using a sewing pattern which
is full in lengthwise direction (+10
mm), make sure of the clearance
between cloth feed base ② and
wiper base ① .If there is no
clearance, loosen setscrew ③ and
move the wiper to the needle side.
Especially when the needle position
comes to the rear on the right side,
the clearance is decreased.
間隙Clearance
①
①
機針Needle
3. Sewing
⑴ Set a workpiece on the work clamp foot
section.
⑵ Depress the pedal switch to the first
step, and the work clamp feet will come
down. If you detach your foot from the
pedal switch, the work clamp feet will go
up.
⑶ Depress the pedal switch to the second
step after descending the work clamp
feet at the first step, and the sewing
machine will start sewing.
⑷ After the sewing machine completes
sewing, the work clamp feet will go up,
and return to the sewing start position.
③
間隙Clearance
②