Siruba LKS-1900AN Instruction Book page 28

7. 廢油槽和機頭支撐橡膠的安裝
⑴用固定螺絲③（2 個）把廢油槽②固定到
機台①的安裝孔上。
⑵把廢油銷④鎖進廢油槽②。
⑶把縫紉機廢油管⑤插到廢油銷④裡
⑷把機頭支撐橡膠⑥插進機台①。
8. 安全開關
請取下固定安全開關②的撥桿部的膠帶①。
注意 :1. 不取下膠帶①使用的話，放倒縫紉機的狀態下縫紉機也會轉動，非常危險。
2. 安裝後，縫紉機動作時如果發生異常 302，請用螺絲起子放鬆安全開關安裝
的下方調整安全開關②的位置。
Caution
:1. It's very dangerous to use the safety switch without removing tape since
2. In case error 302 occurs when the sewing machine works after installation,
P9
③
④
⑤
⑥
⑥
①
④
the sewing machine works even in the state that it is tillted.
loosen the safety switch fitting screw with a screwdriver, and lower the
switch to the downside of the sewing machine.
7. Installing the drain receiver and the head
support rubber
⑴ Fix drain receiver ② to the installing hole
of table ① with two setscrews ③ .
⑵ Screw in drain bin ④ to drain receiver ② .
⑶ Insert sewing machine drain pipe ⑤ into
drain bin ④ .
⑷ Insert head support rubber ⑥ into table
① .
注意 :1. 放倒縫紉機機頭後，廢油管⑤應該
不從廢油銷④脫落，牢牢地插到最
裡面。
2. 請卸下固定廢油管⑤的膠帶。
Caution
:1.Insert drain pipe ⑤ until it will
go no further so that it does
not come off drain bin ④ when
tilting the machine head.
2. Remove the tape which was
used to fix the drain pipe ⑤ .
8. Safety switch
Remove tape ① fixing the lever section of
safety switch ② .
①
②
②