Siruba LKS-1900AN Instruction Book page 64

6. 挑線桿的調整
⑴ 放鬆螺絲①把挑線桿和機針的間隙調整
為 1.5mm 以上。此時的挑線桿和機針的
距離大約為 23 ～ 25mm，通過較寬的調
整，在壓腳下降時可以防止壓到紉機線。
特別是使用細針時，請調寬到 23mm 左
右。
※ 機針為縫製結束停止的位置。
警告
WARNING
7. 廢油的處理
積油杯①裡積滿了油之後，請卸下積油杯①
排放出廢油。
P45
為了防止突然的起動造成人身事故，請關掉電源後再進行操作。
Turn OFF the power before starting the work so as to prevent accidents
caused by abrupt start of the sewing machine.
1.5mm 以上
1.5 mm or more
6. Adjustment of the wiper
⑴ Loosen screw ① to adjust so that a
clearance of 1.5 mm or more is provided
between the wiper and the needle. At
this time, the standard of the distance
between the wiper and the needle is
23 to 25 mm. By adjusting the distance
wider, the work clamp foot can prevent
stepping on needle thread when it
comes down.Especially when the thin
needle is used, adjust the distance wide
to such an extent of 23 mm.
※The position of the needle is when the
sewing mechine has stopped after the
sewing finished.
①
23 ∼ 25mm
23 to 25 mm
7. Draining waste oil
When polyethylene oiler ① becomes filled
with oil, remove polyethylene oiler ① and
drain the oil.
①