Siruba LKS-1900AN Instruction Book page 40

⑺設定結束
1）按
鍵。
2）壓腳移動→上升後，縫製 LED 亮燈，成
為可以縫製的狀態。
鍵之後，圖案 No.、XY 擴大縮小率
✽按
等設定值被記憶。
✽按 鍵之後，可以重新確認各設定項目，
但是縫製 LED 亮燈的狀態不能變更。
鍵之後，準備 LED 滅燈。各項目的
✽按
設定值可以變更。
✽線張力在縫製 LED 亮燈時也可以變更。線張
力用開始 SW 也可以記憶。
✽確認了圖案 No. 之後再使用。在圖案 No.0
顯示（出貨狀態）按
異常 E-10。 此時，請重新設定圖案 No.。
★重要 : 不按
N o .、X Y 擴大縮小率、最高轉速、
線張力的設定值均不能被記憶。
P21
鍵之後，會顯示
開關，關掉電源後，圖案
(7) Finish of setting
1) Press the key.
2) After the work clamp feet have moved
and gone up, the sewing LED lights up,
and the sewing is ready.
注意 : 壓腳上升時，壓腳首先下降
然後再移動，因此請注意不
要夾到手指。
Caution When the presser is
:
raised, be careful that
fingers are not caught
in the presser since the
presser moves after
having lowered.
✽ When key was pressed, the set
values of pattern No., X/Y scale, etc. are
memorized.
✽ If key was pressed, you can make
sure of the respective setting items again.
However, the items can not be changed in
the state that the SEWING LED is lit up.
✽ When key was pressed, the READY
LED goes off. Set values of the respective
items can be changed.
✽ Thread tension can be changed even when
the sewing LED lights up. Thread tension
can be momorized with the start switch as
well.
✽ Use the machine after confirming the
pattern No. When
while pattern No. is indicated "0" (state at
the time of delivery), error display E-10
appears. At this time, reset the pattern No.
★ Important:When turning OFF the power
without pressing
set values of pattern No., X/Y
scale, number of max. rotation,
and thread tension are not
memorized.
key is pressed
key, the