Siruba LKS-1900AN Instruction Book page 55

3. 使用「底線計數器」的縫製
生產計數器可以作為底線計數器使用。反覆
縫製同樣的圖案，1 個梭芯可以縫製的次數
（設定數）縫制結束後，縫紉機變不能起動。
底線計數器採用減算方式。
⑴ 按 鍵，設定為計數器顯示
⑵ 然後按 鍵。
⑶ 然後，按
可以縫製的次數。
⑷ 縫製後，每縫一次計數器減一。
⑸ 縫製完設定數後，踩踏板縫紉機也不開始
縫製。
⑹ 更換底線，按
定值。
⑺ 反覆⑷ ～ ⑹的步驟。
注意 : 計數器的設定在出貨狀態時設定為生產計數器（加算方式）。作為底線計數器使用
時， 必須變換記憶體開關 No.18。 （請參照 「Ⅰ .[8] 記憶體開關的使用方法」 P .49。 ）
Caution
:The counter at the time of delivery is set to the production counter (adding
method).If it is used as the bobbin thread counter, it is necessary to change
over memory switch No. 18. (Refer to the item " Ⅰ .[8] HOW TO USE THE
MEMORY SWITCH" p. 49.)
。
鍵，設定一個旋梭
鍵。計數器值返回到設
3. Performing sewing using the "bobbin
thread counter＂
The production counter can be used as
the bobbin thread counter. In case a same
sewing pattern is sewn in repetition, the
sewing machine will stop sewing when the
number of times (the specified number)
that can be sewn with a bobbin is reached.
The bobbin thread counter is of the
subtracting method.
⑴ Press key to indicate the
Counter .
⑵ Then press the
⑶ Then press the
set the specified number of times that
can be sewn with a bobbin.
⑷ Every time the sewing machine finishes
a sewing cycle, counting-down is made
by one.
⑸ When the sewing machine finishes
the specified number of times, the
sewing machine does not start even if
depressing the pedal.
⑹ Replace the bobbin with a new one,
and press the
counter returns to the set value.
⑺ Repeat the steps of procedure from the
steps ⑷ )to ⑹ .


Introduction
key.
or key, and
key. The value of the
P36