Siruba LKS-1900AN Instruction Book page 54

⑵縫製操作
操作例 : 以登記的 C1 內容進行縫製。
1）打開電源。
2）用
"C1.1＂。
3）按 鍵，縫製 LED 亮燈，然後壓腳
移動，上升。
4）如果圖案形狀良好，則可以縫製。
5）按照每次縫製組合的順序進行步驟，1 迴
圈縫製結束後，返回最初的步驟，可以
反覆進行縫製。
※ 縫製後，如果想返回前面的圖案或跳到下一
圖案時，請在縫製 LED 亮燈的狀態按
鍵、 鍵。圖案顯示變化，壓腳移動到
縫製開始點。
※ 登記 C1 ～ C20 後，改變 P1 ～ P50 的內
容的話， 登記在 C1 ～ C20 中的 P1 ～ P50
的內容也改變，請注意。
※ 每種圖案均應確認圖案形狀。 （請參照Ⅰ
.[5]-2. 圖案形狀的確認 P .22 之項。）
P35
鍵把圖案號碼設定為
(2) Sewing operation
Operation example : Perform sewing with
the contents of the registered C1.
1) Turn ON the power switch.
2) Set the pattern No. to "C1-1 ＂ using
the or
follows :
3) Press the
LED lights up, the work clamp feet will
go up after movement.
4) If the contour of the pattern is
acceptable, the sewing can be made.
5) Every time the sewing is finished,
the step is made in the order of the
combination. After completing one
cycle of sewing, the step returns to the
first step. The sewing can be made
repeatedly.
※ When you desire to return the pattern to
the previous one or skip the next pattern
after sewing, press
a state that the sewing LED lights up.
The indication of the pattern will change,
and the work clamp feet will move to the
sewing start point.
※ If the contents of P1 to P50 are changed
after registration of C1 to C20, the
contents of P1 to P50 used in C1 to C20
will change. So, be careful.
※ Make sure of the contour of the pattern for
each of the patterns. (Refer to the item "
Ⅰ .[5]-2.Checking the contour of a sewing
pattern" p.22.)



key. Scroll as
key. When the sewing
or key in