How To Set The Clock (Date And Time) - Datascope Accutorr Plus Service Manual

1.3.13

HOW TO SET THE CLOCK (Date and Time)

The clock can be set during normal operation or in the User Configuration. See section
1.3.15, for details on entering the User Configuration. The Timer/Temp key (32),
Interval/Elap. Time/Temp Display (33), and the Up and Down arrow keys (27 & 28) are
used to set the time and date. PRECAUTION: Changing any part of the time or date
will cause all stored patient information (trend data) to be permanently erased. Viewing
the time or date does NOT cause data to be erased.
1. Press and hold the Timer/Temp key (32)
(2 beep tones, approx. 6 seconds). The hour
digit only displays.
2. Press the Patient Info. Up or Down Arrow
key (27 or 28) to change the number.
NOTE: The Accutorr Plus always displays
time in a 24 hour format.
3. Press the Timer/Temp key (32) to activate
the minute display.
4. Press the Patient Info. Up or Down Arrow
key (27 or 28) to change the number.
Continue pressing the Timer/Temp key
and the Arrow keys to set the month, day,
and year (in that order).
5. After the year has been selected, the next
press of the Timer/Temp key (32) exits the
clock set mode and enters the new
information.
To cancel a changed value while that value
is still displayed, press the DEFAULTS
key (14) for less than 3 seconds.
If the TIMER/TEMP or Arrow keys have not
been pressed for 15 seconds, the Accutorr
Plus returns to normal operation and saves
any Time/Date changes.
When the clock is displayed, it displays real-time
(current time). When the clock is displayed while
viewing previous data, frozen time is displayed.
When frozen time is displayed, the colon
between the hours and minutes is illuminated
continuously. When real-time is displayed the
colon between the hours and minutes flashes.
Accutorr Plus Service Manual
Chapter 1, Operation
Hour
Display
TIMER/TEMP
Press and hold
INTERVAL ELAP . TIME TEMP
to enter the clock
ALARMS
set mode. Set hour,
SET
MUTE
ALARMS then press again to
set the minute.
Press to Change
Figure 1-19 - Setting the Hour
Minute
Display
TIMER/TEMP
After the time
INTERVAL ELAP . TIME TEMP
and date have
ALARMS
been set, press
SET
to exit the clock
MUTE
ALARMS
set mode.
Press to Change
Figure 1-20 - Setting the Minute
1-47
Revised 02/15/00