Cover, Ui Upper Assembly (Speakers) Replacement - GE LOGIQ E10 Basic Service Manual

Hide thumbs Also See for LOGIQ E10:

Table of Contents

5750007-1EN, R

Cover, UI Upper Assembly (Speakers) replacement

Table 8-155 Manpower / Time and Tools

One person /

Table 8-156 Preparations and Preparation Links

Energy Control and Power Lockout for LOGIQ E10:

When servicing parts of the Ultrasound System where there is exposure to voltage greater than 30

1. TURN OFF THE SCANNER.

2. UNPLUG THE SYSTEM.

3. MAINTAIN CONTROL OF THE SYSTEM POWER PLUG.

4. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE AND THE ON/OFF

BUTTON (WHITE LIGHT ON THE OP PANEL) TO TURN OFF, AS THERE ARE NO TEST POINTS

TO VERIFY ISOLATION.

5. REMOVE THE BATTERY COVER AND DISCONNECT THE POWER CABLES J10 and J11 (black

and red) FROM THE BACKPLANE. See:

replacement" on page

Beware that the Main Power Supply, the Batteries, Power Module, ECB Shear Wave Capacitor Pack

may be energized, even if the power is turned OFF if the cord is still plugged into the AC Outlet.

1. Power down the system.

2. Disconnect the mains power cable from the wall outlet and all Probes and External I/O Cabling.

3. Remove the Left Side Cover , the Battery Cover , the Upper OP/Touch Panel Assembly, the Monitor, Monitor Arm and

Arm Adapter.

Preparation Links (if you need more information):

• 4-2-4 "Power SHUT DOWN" on page 4-9.

• 8-6-3 "Side Cover(s)/Side Air Intake (Filter) inspection / replacement" on page

• 8-7-9 "Upper OP (Operator Panel)/Touch Panel Assembly replacement" on page 8-117.

• 8-7-2 "Main Monitor assembly replacement" on page 8-84.

• 8-7-3 "Main Monitor Arm assembly replacement" on page 8-91.

• 8-7-4 "Main Monitor Arm Assembly Adapter replacement" on page 8-99.

8-2-5 "Tools needed for servicing the LOGIQ E10" on page 8-6

8-2-6 "PPE Required During Service" on page

Preparations - you must perform the following steps

Chapter 8 Replacement Procedures

8-2-2 "Warnings" on page 8-3

8-11-15 "Rear I/O

Table of Contents