Table of Contents
Advertisement
7
Software Installation
Install CardioSoft and the USB driver on your PC only if
you are familiar with the Windows operating system.
CardioSoft from version 6.73 SP2 and the USB driver
run only under these operating systems: Windows 8.1 Pro
and Enterprise 64-bit as well as Windows 7 Professional
32-bit, 64-bit.
CardioSoft version 6.7 (except 6.73 SP2) and the USB
driver run only under these operating systems: Windows
7 Professional 32-bit, 64-bit, and Windows XP
Professional 32-bit with Service Pack 3.
CardioSoft version 6.6 and the USB driver run only
under these operating systems: Windows XP
Professional, Windows Vista Home Premium 32-bit, and
Windows Vista Business 32-bit.
CardioSoft pre version 6.6 and the USB driver run
under these operating systems: Windows 2000, Windows
XP Professional, Windows Vista Home Premium 32-bit,
and Windows Vista Business 32-bit.
CardioSoft (Standalone Workstation)
You will need administrator privileges for installation of
the USB driver.
1.
Turn on the PC and the monitor. Exit ALL
programs.
2.
Insert the CardioSoft CD in the CD ROM drive. If
the CD drive does not automatically start up, start
"setup.exe" (on the CardioSoft CD, "Disk1" or
"CASE-CS" folder) via the Windows Explorer.
3.
Follow the displayed prompts.
4.
Confirm the two proposed directories with Next.
5.
Enter the serial number (see CD-ROM).
CardioSoft will now be installed on your computer.
6.
Restart Windows.
If you will be using the serial port of TONOPORT V
(Fig. 5-1, b) installation is now complete.
To be able to use the USB port of TONOPORT V
(Fig. 5-1, a), you will have to install the USB driver
and check the communication as described below.
2001589-085 Revision G
Software Installation
Note
USB Driver
You will need administrator privileges for installation of
the USB driver.
1. Turn on the PC and the monitor. Exit ALL
programs.
2. Insert the CD with the USB drivers in the CD ROM
drive. If the CD drive does not automatically start
up, start "setup.exe" (on the USB driver CD,
"Disk1" folder) via the Windows Explorer.
3. Follow the displayed prompts. Select Allow if the
system informs you that you are using an
unidentified program.
4. Click Finish to complete the first part of the USB
driver installation procedure.
5. Turn on TONOPORT V and connect it to the PC,
using the USB connection cable.
Windows will automatically detect TONOPORT V
(TUSB3410).
6. Follow any additional prompts that may be
displayed.
7. When Windows indicates that the drivers were
successfully installed and the new hardware can be
used, remove the USB driver CD from the CD-
ROM drive.
TONOPORT V
24
Advertisement
Table of Contents
