Table of Contents
Advertisement
Chapter 7: Cabling the Networking Ports
Installing SFP Transceivers
91
This section contains installation instructions for SFP transceivers. These
illustrations show SFP ports 9 and 10 on the x320-10GH switch.
The illustrations show a transceiver with a duplex LC connector. The
connectors on your transceivers may be different. Please review
"Guidelines to Handling SFP Transceivers" on page 90 before performing
this procedure.
To install transceivers, perform the following procedure:
1. Select a port for the transceiver.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. To install the transceiver, position the transceiver with the Allied
Telesis label facing up. Refer to Figure 49 on page 92.
Figure 48. SFP Ports 9 and 10
Advertisement
Table of Contents
