Powering On The X320-10Gh Switch; Connecting The Pwr300 Power Supply; Figure 53: Connecting The External Harness To The X320-10Gh Switch - Allied Telesis x320 Series Installation Manual

Chapter 8: Powering On the Switch

Powering on the x320-10GH Switch

Connecting the
PWR300 Power
Supply
95
The x320-10GH switch requires an external harness to connect to the
external PWR300 power supply. The x320-10GH switch can support up to
three PWR300 power supplies. Each PWR300 power supply provides
240W PoE power.
To connect the PWR300 power supply to the x320-10GH switch:
1. Verify that the PWR300 power supply is powered off.
Warning
Leaving the power supply powered on while connecting the harness
to the switch could cause an electrical short that can damage the
equipment. E127

2. Connect one end of the external harness to the x320-10GH switch.
Refer to Figure 53.
Figure 53. Connecting the External Harness to the x320-10GH Switch
Caution
Do not install the connector at an angle, doing so can bend the
connector pins. E128
