Figure 51: Positioning The Sfp Handle In The Upright Position; Figure 52: Connecting A Fiber Optic Cable To An Sfp Transceiver - Allied Telesis x320 Series Installation Manual

Chapter 7: Cabling the Networking Ports
93
5. Verify the position of the handle on the transceiver. the handle should
be in the upright position, as shown in Figure 51.
SFP Handle
Figure 51. Positioning the SFP Handle in the Upright Position
6. Connect the fiber optic cable to the transceiver, as shown in Figure 52.
The connector on the cable should fit snugly into the port, and the tab
should lock the connector into place.
Figure 52. Connecting a Fiber Optic Cable to an SFP Transceiver
7. Repeat this procedure to install an additional transceiver.