Table of Contents
Advertisement
Chapter 7: Cabling the Networking Ports
Cabling Twisted Pair Ports
89
Here are the guidelines to cabling the twisted pair ports:
The cable specifications for the twisted pair ports are listed in
"Cable Requirements" on page 21.
PoE is enabled by default on the ports of the x320-10GH switch.
The connectors on the cables should fit snugly into the ports, and
the tabs should lock the connectors into place.
The default speed setting for the ports is Auto-Negotiation. This
setting is appropriate for ports connected to network devices that
also support Auto-Negotiation.
The ports must be set to Auto-Negotiation, the default setting, to
operate at 1000Mbps.
The ports support half- and full-duplex at 10Mbps or 100Mbps.
The ports support only full-duplex at 1000Mbps.
Do not attach cables to ports of static or LACP trunks until you
have configured the trunks of the switch. Otherwise, the ports will
form network loops that can adversely affect network performance.
Advertisement
Table of Contents
