Table of Contents
Advertisement
Chapter 3: Installing the Device on a Table or Desktop
53
Note
The bumper feet are only to be used if you are installing the switch
on a table. Do not install the bumper feet if you are installing the
switch in an equipment rack or on a wall.
5. Turn the device over and place it on the table or desk. See "Required
Minimum Distances Between Devices for a Desk or Table Installation"
on page 51.
6. After placing the switch on the table or desktop, go to Chapter 7,
"Cabling the Networking Ports" on page 88.
Advertisement
Table of Contents
