Installing the Switch on a Table or Desktop
This section contains the procedure for installing the switch on a table.
Warning
Switches should not be stacked on a table or desktop. They could
present a physical safety hazard if you need to move or replace
switches. E91
To install the chassis on a table, perform the following procedure:
1. Review the procedure in Chapter 2, "Choosing a Site for the Switch" on
page 42 to verify that the selected site is suitable for the unit.
2. Check to be sure that the table is strong enough to support the weight
of the switch.
3. Lift the device from the shipping box and place it upside down on the
table or desk.
4. Affix the four adhesive feet to the four corners of the bottom of the
switch, as shown in Figure 16.
Figure 16. Affixing the Adhesive Feet
x320 Series Installation Guide
52